Hirschmann Switch MRP Ring Network Configuration

Jun 11, 2025 Leave a message

Note: First disconnect the switch ring network and make the network into a bus structure to avoid physical rings causing network storms. Set all the DIP switches of the switch to ON (DIP on the right). Only in this way will the switch software configuration not conflict with the DIP switch function.

 

The ring network port has the following requirements: The 100M electrical port used as a ring network port must be a non-adaptive port with forced rate and duplex.

 

This manual uses Port1.5 and Port1.6 as the ring network ports.

 

1. Log in to the switch configuration interface and change Port1.5 and Port1.6 to non-adaptive ports.

Automatic Configuration: Uncheck the default adaptive function, Port1.5 and Port1.6 are non- adaptive ports.

Click Set to save.

 

info-1080-465

 

2. Disable RSTP function on the switch

This case uses full closure

Operation: Select Off to disable the RSTP function.

Click Set to save.

 

info-1080-551

 

3. Configuring (non-manager) switch MRP ring ports

Version: Select MRP protocol

Ring Port 1: Select the ring port Port1.5

Ring Port 2: Select the ring port Port1.6

Configuration Ring Manager: Check Advanced Mode to enable the fast switching function

Ring Manager: Select Off, non-ring manager

Operation: Select On to enable the MRP function

Ring Recovery: Select 200ms to improve the ring network recovery capability

VLAN ID: Use the default value

Click Set to save.

 

Note:

Delete ring configuration: Click this button to delete the original ring network port configuration.

 

info-1080-624

 

4. Configure the (Manager) switch MRP ring network port (one and only one is needed for one ring)

Version: Select MRP protocol

Ring Port 1: Select the ring port Port1.5

Ring Port 2: Select the ring port Port1.6

Configuration Ring Manager: Check Advanced Mode to enable the fast switching function

Ring Manager: Select On to set it as a ring manager

Operation: Select On to enable the MRP function

Ring Recovery: Select 200ms to improve the ring network recovery capability

VLAN ID: Use the default value

Click Set to save.

 

Note:

Delete ring configuration: Click this button to delete the original ring network port configuration.

 

info-1080-615

 

5. Save the switch configuration:

Save: Select to Device

Click Save

 

info-1080-412

 

After configuration, connect the ring network.