1. The impact of environment on relay reliability: The average time between failures of relays operating in GB and SF is the highest, reaching 820000 hours, while in NU environment, it is only 60000 hours.
2. The impact of quality level on relay reliability: When using A1 quality level relays, the average time between failures can reach 3660000 hours, while using C level relays has an average time between failures of 110000 hours, a difference of 33 times. It can be seen that the quality level of relays has a significant impact on their reliability performance.
3. The influence of contact form on the reliability of relays: The contact form of relays also affects their reliability. The reliability of single throw relays is higher than that of double throw relays with the same number of poles, and the reliability gradually decreases with the increase of pole number. The average fault interval time of single throw relays is 5.5 times that of four throw relays.
4. The influence of structural types on relay reliability: There are 24 types of relay structures, and each type has an impact on its reliability.
5. The influence of temperature on the reliability of relays: The working temperature range of relays is between -25 ℃ and 70 ℃. As the temperature increases, the average fault interval time of the relay gradually decreases.
6. The impact of action rate on relay reliability: With the increase of relay action rate, the average time between failures generally shows an exponential downward trend. Therefore, if the designed circuit requires a very high action rate of the relay, it is necessary to carefully inspect the relay during circuit maintenance in order to replace it in a timely manner.
7. The impact of current ratio on the reliability of relays: The so-called current ratio refers to the ratio of the working load current of a relay to the rated load current. The current ratio has a significant impact on the reliability of relays, especially when the current ratio is greater than 0.1, the average fault interval time rapidly decreases, while when the current ratio is less than 0.1, the average fault interval time remains basically unchanged. Therefore, in circuit design, a load with a higher rated current should be selected to reduce the current ratio, which can ensure that the reliability of the relay and even the entire circuit is not reduced due to fluctuations in operating current.


