In industrial environments such as coal mines, with the increase of coal mine terminals and sensor data and the growth of the number of systems, reasonable division of VLANs is very beneficial to improving network performance, security and management efficiency.
Unnecessary data traffic is reduced, thereby improving the utilization of network bandwidth. Quick fault location: When a problem occurs, the administrator can quickly determine which VLAN has a problem, reducing the troubleshooting time. As the coal mine business develops, new VLANs can be easily added to adapt to new needs and equipment. After dividing VLANs, there is also an additional problem: each VLAN will be a network segment, and the network IP must be planned, which requires basic network management personnel to perform simple operation and maintenance.
Differences between Access and Trunk Ports
Access Port has only one VLAN assigned as PVID
|
Enter |
go out |
|
Tagged frames: if = pvid, receive, otherwise discard Untagged frames: process as PVID VLAN |
VID = PVID, remove the tag VID ≠ PVID, will not be sent to this port |
A Trunk Port has only one PVID and multiple fixed VLANs
|
Enter |
go out |
|
Tagged frames: Accept if tag VID=PVID or fixed VLAN (tagged). Untagged frames: add PVID VLAN tag Disable VLAN (setting) is not an ingress/egress filter, this setting is used to enable GVRP |
If =PVID, remove the tag If ≠PVID, keep the label |
Example
Trunk: T
Access: A

The most direct memory method
The access port is used to connect terminal devices and provide access to a single VLAN.
Trunk ports are used to connect switches and provide transmission of multiple VLANs.
Type: interface type, Access, Trunk
Tagged VLAN: When creating a VLAN, simply add the VLAN number

Recommendation: Disable GVRP immediately
Ring network backbone Trunk and official base station Gigabit optical Trunk port

Service system VLAN

VLAN Name Setting: Business VLAN Remarks


Switch local interface
Peer switch/terminal


